Best Tips on Repairing a Washer In Union City CA 

Repairing your washer can save you a lot of money and time because you will not have to wait for a professional to do it for you. However, a job well done is what satisfies most rather than doing it yourself. If you are to repair your own washer, you need to have necessary equipment. Some of the tools you need include a screwdriver, pliers and a ball point hammer (though you may not need it).

The first thing you need to do when repairing your washer is to know the problem. If your washer does not run nor do you hear any sound, you need to check whether it is plugged in to a source of power. If it’s already plugged in, check the circuit breaker to determine whether it has tripped due to an overload. If none of these seem to be the problem, you will have to check and see whether the water is turned on and the hose is connected. If everything is fine, you will have to call in a washer repair in Union City, CA or replace your washer.

If your washer is making some noise, there is enough power and you might not have any electrical problem. You need to check whether the washer is filling up with water and if the water is filling to the right level. If the water is not filling to the right level, make sure that the water supply is turned on and check its pressure to ensure it is okay. You can also check the drainage of the water hose (it should be at 38 inches or in level with the top washer). The hose should neither be clogged nor should it be pulled tautly near the main drain. After checking all these and your washer still has a problem, consider hiring a washer and repair in Union City.

If you have a problem with the cycles or the water, an appliance repair service in Union City would recommend you replace the timer. Make sure you list down the model number and brand of the timer to make sure it will be compatible. To replace the timer, make sure that the washer is not plugged in and then remove the knobs and the control panel. Look for the wires that connect the timer and the washer and as you disconnect each wire, connect it to the new timer to ensure you’ve connected properly.

You may have to change the inlet valve if water level is the problem. You need to buy a compatible inlet valve for it to work with your washer. If you cannot be able to change the inlet valve yourself, hire an appliance repair in Union City to do it for you. The process might involve a lot of steps which may require you to be skilled to do it well.

Finally, if the washer won’t agitate, consider repairing or replacing it. First of all, make sure it is not cracked to prevent your clothes from getting caught inside. With sand, you can repair the jagged pieces. However, if it does not fix the problem, it is wise to change the agitator.

Union City Appliance
Union City, CA 94587
unioncityappliance.com
(510) 319-9397

Leave a Reply

Your email address will not be published. Required fields are marked *